Re: How to setup a Relay (General questions)
Hamed,
Basically this is full code you need to use on some machine to start relay:
[code]Set vpn = New wodVPNCom
vpn.Password = somepassword
vpn.Relays.Add 3003[/code]
both peers should then inside Connect Method use IP of relay and Port (in this case 3003) to connect to other peer over relay.
Can you try something like that and let us know how ti goes? Also, if you didn't already check, we have samples for wodVPN. You can find them inside component Samples folder.
Drazen
Complete thread:
- How to setup a Relay - Hamed, 2011-11-06, 15:12
- Re: How to setup a Relay - wodDamir, 2011-11-06, 15:24
- Re: How to setup a Relay - Hamed, 2011-11-07, 08:47
- Re: How to setup a Relay - woddrazen, 2011-11-07, 09:15
- Re: How to setup a Relay - Hamed, 2011-11-09, 11:41
- Re: How to setup a Relay - woddrazen, 2011-11-09, 11:46
- Re: How to setup a Relay - Hamed, 2011-11-09, 11:41
- Re: How to setup a Relay - woddrazen, 2011-11-07, 09:15
- Re: How to setup a Relay - Hamed, 2011-11-07, 08:47
- Re: How to setup a Relay - wodDamir, 2011-11-06, 15:24