Re: - WeOnlyDo Discussion board

Re: (General questions)

by wodDamir, Tuesday, March 30, 2010, 15:59 (5354 days ago) @ Ben

Ben,

When PORT is used, then server initiates connection towards client, and client needs to provide server IP and port where to connect. However, if client is behind a firewall or NAT, then this mode is usually impossible to use.

I assume that client in this case sent PORT command along with local (LAN address) which server interpreted as invalid.

In order to get full, licensed version you can request it here: http://www.weonlydo.com/index.asp?update=1

Just make sure that you provide the e-mail that was registered on our system when the component was purchased.

Regards,
Damba


Complete thread: